KITSCM
$3,921.20 EA

STYROCUT HOT WIRE

KITSCM

FOAM CUTTER W/ MAGNUM **NW100 WIRE & INSTRUCTIONS**

Weight

185 lbs.
+ Click image to enlarge
Previous
  • Thumbnail
  • Thumbnail
  • Thumbnail
Next
Videos
  • Video Thumbnail
  • Video Thumbnail

STYROCUT 15, 4 ft HOT WIRE EPS FOAM CUTTER

 

Our Best Hot Wire EPS Board Foam Cutting Machine!

  • Use to Cut EPS Foam In-Plant or on Job Sites

  • Foot-Pedal Motion Control

  • Designed by Engineers To Cut Straight, Channel, Angles and Tapers in EPS Foam

  • Portable; Weighs Only 117 Pounds

  • Capable of Vertical and Horizontal Hot Wire Foam Cuts

  • Table Tilts and Locks 0 - 45°

  • Cuts 15" Deep by 4' Wide

  • 60"-Wide Cutting Table by 27" Deep

Note: Heated Wire expands when hot. If the spring is too tight the wire may break restricting operation of mechanism. If too loose, the
cut will be sloppy. Readjustment of tension may be necessary from time to time.


Safety Tips


Power Controller – Use nothing longer than a 50 foot 12/3 grounded extension cord. Set the temperature dial on the controller to zero (0). Turn on the hot wire power controller and adjust the dial until the wire glows orange. Immediately back off the controller until the heated wire just begins to turn from orange to gray. This is the optimum foam cutting temperature of the wire.  Anything hotter will cause premature wire failure or anything cooler will require too much feed pressure on the wire causing premature failure. If the wire is too hot, the cut may not be as accurate as you would like. A wire that is too hot will melt the foam too quickly at the beginning of the cut and less quickly as the wire cools off resulting in an inaccurate cut.


• Use only the recommended wire. NW100

• Do not use this equipment in wet or damp conditions.
• Use only grounded receptacles.

Yes, I would like to get more information from my sales technician.